motionfert.blogg.se - Amplificateur antenne tv 12 volts

#AMPLIFICATEUR ANTENNE TV 12 VOLTS MANUALS#
#AMPLIFICATEUR ANTENNE TV 12 VOLTS INSTALL#
#AMPLIFICATEUR ANTENNE TV 12 VOLTS TV#

Is there any difference between powering with 12 Volt or 220 V?.

You can use either a12 V dc or you can purchase the V9117 220 V dc power adapter.

What power supply will need to power my amplifier?.

#AMPLIFICATEUR ANTENNE TV 12 VOLTS INSTALL#

Included in your package there is black bulkheads mount to install that will accommodate the amplifier, you will still need to drill a hole to accommodate the entry of the coax connections. What if I don’t want to cut my bulkhead to install the amplifier?.The amplifier should be installed in a dry well ventilated place that provides easy access to the gain A/B switch built into the unit. Where should the amplifier be installed?.

#AMPLIFICATEUR ANTENNE TV 12 VOLTS TV#

Included in your Glomex Marine TV Antenna package is a flack plastictool this tool is designed to slide over the coax and grip the connector so it maybe twisted on.

How do I get the “F” connector into the base of the antenna?.

Use only “F” gold connectors for TV wire 6.8 mm or a wire with the same diameter of the used one.

How can I tell if a cable is either low loss or not?Ī high-quality low loss cable will have a white foam center insulator where a lower grade of cable will be opaque and solid.

We recommend that you use only a DSS quality cable. It is important to use only RG6 Twin Screen low loss cable. Make sure that the Glomex dome is either above or bellow the radar array and never on the same “plane” as the array.

If I mount it on a radar arch, will the array interfere with the reception?.

Your antenna should be mounted free and clear of any obstruction and as high as possible.

Where I best to install my new Glomex Antenna?.

Installation Trouble Shooting Guide for TV antennas 5) until it is well tighte-ned by the rib in relief (fig. Screw it (about 7 turns for Nashira and 6 turns for Talitha) (fig. 3) clockwise and in perpendicular position (fig. Put the O-ring in the hole on the radome (fig. Thanks to vertical antenna inside the “shark fin”, Nashira and Talitha can receive TV signals vertically polarized. Remember each splice represents again loos of + 1.5 d.B or more. When splicing with connectors, use only 75 Ohm connectors only. The coax cable should never be spliced wire-wire.

This will provide the best performance from your Glomex TV antenna.

Splicing Installation Notes: It is always better to run new coax cable of the proper length and quality, as the 20 mts supplied with the antenna, without splices. Do NOT staple coax to bulkhead TWIST-ON F CONNECTOR INSTALLATION INSTRUCTIONS COAX SPLICING.Use screw-up wire ties to secure to bulkheads.Do NOT bend the coax cable in a radius less than 21/2”.Keep clear the antenna from any obstructions.Mounting a TV antenna next to or just above a flat metal surface may cause “ghosting” on the picture.V9173 TV Masthead Mount Bracket for 14” antenna V9112/12 or V9150/12 V9123 Masthead Mount Bracket for 10” antenna V9125/12 Installation Notes

#AMPLIFICATEUR ANTENNE TV 12 VOLTS MANUALS#

12.2 Related Manuals / Resources GLOMEX V9123-12 Television Antennas SAILBOAT ANTENNA INSTALLATION LOCATION